Maintenance Schedule - Scantron iNSIGHT 30 Operator's Manual

Maintenance Schedule

Procedure
Clean separator module
tires
Clean feed module tires
Clean drive rollers and
transport area
Operator's Guide
Use the following table as a guide to routine maintenance.
Usage figures are not guaranteed. Customer-operating
environments, document type, the condition of
documents being scanned, and not following the
recommended cleaning and replacement procedures, can
cause the life of the consumables to vary.
Interval
As required depending
on the type of scanning
being performed.
As required depending
on the type of scanning
being performed.
As required depending
on the type of scanning
being performed.
Chapter 4: Maintenance

Maintenance Schedule

What to Use
Use staticide wipe (part
number 830 9783) -- slightly
damp. Allow to air dry
before scanning.
Use staticide wipe, (part
number 830 9783) -- slightly
damp. Allow to air dry
before scanning.
Run transport cleaning
sheet, (part number 896
2201). If required, use
emulsiclean wipe, (part
number 137 4966) on red
and white rollers. Allow to
air dry.
DO NOT USE
CAUTION:
THE EMULSICLEAN
WIPE ON THE
FOAM TIRES.
73