Installing The Insight 20 And Insight 30 Drivers And Scanner Utilities Software - Scantron iNSIGHT 20 Operator's Manual

Chapter 3: Installation

Installing the iNSIGHT 20 and iNSIGHT 30 Drivers and Scanner Utilities Software

Installing the iNSIGHT 20 and iNSIGHT 30 Drivers and
Scanner Utilities Software
48
Install the software
CAUTION:
ner to the PC.
The iNSIGHT 20 and iNSIGHT 30 Drivers and
NOTE:
Scanner Utilities software supports only one scanner
connected to the host computer at a time.
The iNSIGHT 20 and iNSIGHT 30 Drivers and Scanner
Utilities installation program installs the following
software:
• TWAIN Driver: The software utility program that
controls the scanner.
• Scan Validation Tool: A software program that
enables you to test the scanner's document imaging
capabilities.
• Click&Scan: A software program that allows you to
perform document imaging tasks with just a few clicks
of your mouse.
• Calibration Utility: A software program that is used
during setup to calibrate the scanner for data
collection. After setup, this program should not be
used unless the scanner has been moved to a different
computer, the scanner has been exchanged for a new
one, or you are directed to do so by Scantron
Customer Support.
• Scanner Exerciser: A software utility program that
Customer Support uses to test the data collection
capabilities of the scanner.
Some of the software above requires the
NOTE:
Microsoft .Net Framework to function. The
installation routine will also install the .Net
Framework if it is not already installed.
before
connecting the scan-
Scantron iNSIGHT 20 Scanner