Print Mode Settings; Allocate Memory - Fuji Xerox DocuCentre-II 2055 User Manual

11 System Settings

Print Mode Settings

In [Print Mode Settings], you make settings relating to the printer feature.
When using CentreWare Internet Services, more detailed settings are possible. For more details, refer to
CentreWare Internet Services (P.230), and refer to the Network Administrator Guide.
The following shows the reference section for each item.
1
On the [System Settings] screen, select [System Settings].
11
For the method of displaying the [System Settings] screen, refer to System Settings Procedure (P.258).
2
Select [Print Mode Settings].
3
Select the item to be set or changed.

Allocate Memory

For each interface, set the memory capacity for the receiving buffer (temporary storage
for data sent from the client).
You can change the receiving buffer capacity depending on the pattern of use and
purpose. Increasing the receiving buffer capacity may allow a client to be released
sooner from an interface.
Important • If you change the memory capacity settings, the memory is reset, and therefore data stored
Note
PostScript Memory
Specify a value for the PostScript memory capacity from 16.00 to 96.00 MB in 0.25 MB
increments.
Note
ESC/P Form Memory
Displays destination to save forms used in ESC/P.
If a hard disk is not installed, data can be stored in the ESC/P form memory. You can specify
the value within the range from 128 to 2048 KB in 32 KB increments.
Note
308
Allocate Memory ......................................................................................................................308
Delete Form...............................................................................................................................310
Other Settings............................................................................................................................311
in all memory areas is lost.
• It is not possible to assign more than the total memory. When the power is turned on, if the
settings exceed the available memory capacity, they are automatically adjusted by the
system.
• When a port is set to [Disabled], the corresponding items do not appear.
• Depending on the amount of data sent from the client, increasing the memory capacity may
not change the time taken to release the client.
• This feature does not appear for some models. An optional package is necessary. For more
information, contact our Customer Support Center.
• The maximum value that can be set varies according to the available memory capacity.
• This feature does not appear for some models. An optional package is necessary. For more
information, contact our Customer Support Center.
• The maximum value that can be set varies according to the available memory capacity.