Upgrading Or Replacing Processors; Preliminary Steps; Upgrading Or Replacing A Processor - Fujitsu PRIMERGY TX2540 M1 Upgrade And Maintenance Manual

11.4

Upgrading or replacing processors

Field Replaceable Unit
(FRU)
Tools: Phillips PH2 / (+) No. 2 screw driver
V
CAUTION!
Processors are extremely sensitive to electrostatic discharge and must
be handled with care. After a processor has been removed from its
protective sleeve or from its socket, place it upside down on a
nonconducting, antistatic surface. Never push a processor over a
surface.

11.4.1 Preliminary steps

"Disabling BitLocker functionality" on page 77
Ê
"Disabling SVOM boot watchdog functionality" on page 78
Ê
Ê If applicable, "Locating the defective server" on page 45
"Shutting down the server" on page 48
Ê
"Disconnecting the server from the mains" on page 48
Ê
"Getting access to the component" on page 49
Ê
"Removing processor heat sinks" on page 286
Ê

11.4.2 Upgrading or replacing a processor

I
This description applies to the following procedures:
– Installing the second processor in a single-processor configuration
– Transferring a processor after replacing the system board (see
section
Ê In case of installing a second processor remove the protective cover as
described in section
TX2540 M1
"Replacing the system board" on page
"Removing the protective cover" on page
Upgrade and Maintenance Manual
Hardware: 15 minutes
Software: 5 minutes
362)
Processors
272.
281