Engine Oil Level Inspection; Recommended Engine Oil - Linhai ATV 260 Service Manual

CHAPTER 3A ENGINE
1,120 kP a (11.2 kg /cm
Measurement steps :
Crank the engine with the throttle wide open until
reading on the compression gauge stabilizes.
WARNING :
Before cranking the engine, ground all spark plug
leads to prevent sparking.
8. Install:
Spark plug

3.2.5ENGINE OIL LEVEL INSPECTION

1. Start the engine and let it warm up for a few
minutes .
2. Turn off the engine.
3. Inspect: (Do not thread dipstick in)
Engine oil level
Oil level should be between maximum and
minimum marks "2" .
Oil level is below the minimum mark
to the proper lever.

RECOMMENDED ENGINE OIL

Refer to the chart for selection of the oils suited
to the atmospheric temperature.
API STANDARD:
API SE or higher grade
CAUTION:
Do not put in any chemical additives or use
oils with a grade of CD or higher.
Be sure not to use oils labeled
"ENERGY CONSERVING I" or higher. Engine
oil also lubricates the clutch and additives
could cause clutch slippage.
Be sure no foreign material enters the
crankcase.
4. Start the engine and let it warm up for a few
minutes.
5. Turn off the engine.
NOTE:
Wait a few minutes until the oil settles before
260/ 300 cc
2
, 11.2 bar)
Add oil up
ATV SERVICE MANUAL07.0
CHAPTER 3 ENGINE PAGE. 3A- 12