For B-Type Atv; Vent Lines And Roll Over Valve - Linhai ATV 260 Service Manual

CHAPTER 2 MAINTENANCE

FOR B-TYPE ATV

Fuel strainer screen cleaning:
1. Remove the fuel tank.
2. Drain the gasoline into an approved fuel
container. Remove the two mounting
bolts, collars and the fuel valve.
3. Remove the O-ring and fuel strainer
screen.
4. Clean the
non-flammable
solvent. Dry
thoroughly.
5. Install the strainer screen and a new
O-ring onto the valve.
6. Install the fuel valve onto the fuel tank.
7. Install the collars and mounting bolts, and
tighten the bolts securely.
NOTE
After installing the fuel valve and connecting
the fuel line, refill the fuel tank and turn the
fuel valve ON and check that there is no fuel
leaking.
WARNING
Always pay attention to the fittings of the
plastic gas tank during fuel lines service.
Don't pull the line from the tank directly for
removal. Inspect fittings and tank body for
looseness, nicks, and scratches. Replace
gas tank if necessary.
°

VENT LINES AND ROLL OVER VALVE*

1. Check fuel tank, oil tank, carburetor,
battery, and transmission vent lines for
signs of wear, deterioration, damage or
leakage. Replace every two years.
2. Be sure vent lines and drain lines are
routed properly toward the ground and
secured with cable ties. CAUTION: Make
sure lines are not kinked or pinched
*NOTE. On some models, there is a
Roll-Over Valve on the end of the gas tank
vent line. Make sure the ↑ mark on the
R-O Valve is upwards.
strainer screen
or high flash
the strainer screen
with
point
B-TYPE ATV
CHAPTER 2
ATV SERVICE MANUA 07.0
MAINTENANCE PAGE. 2- 10