Float Bowl Disassembling - Linhai ATV 260 Service Manual

Hide thumbs Also See for ATV 260:
Table of Contents

Advertisement

CHAPTER 3B ENGINE 50cc/80cc

Float Bowl Disassembling

Disassembling three screws and take off float
bowl.
Remove float pin spring.
Remove high speed jet, low speed jet and fuel
volume control screw.
· Be careful not to break fuel jets and control screw.
·Count the turns when removing the fuel volume
control screw.
·When reinstalling jets and screws do not over
tighten.
Clean jets with solvent and compressed air.
Clean body of carburetor by air blowing through all
passages.
Checking
Check float valve, and valve seat for damage.
Check float valve and valve seat wear, pitting or
build up of dirt.
Any leakage of the valve or a build up of dirt will
affect the fuel level in the float bowl and cause
drivability problems.
ATV SERVICE MANUAL07.0
CHAPTER 3B ENGINE
PAGE 3B - 56 -

Advertisement

Table of Contents
loading

Table of Contents