Linhai ATV 260 Service Manual page 58

CHAPTER 3A ENGINE
Fit the timing chain onto the cam sprocket and
install the cam sprocket on the camshaft.
NOTE:
When installing the cam sprocket, keep the
timing chain as tense as possible on the exhaust
side.
Align the match mark ○
with the stationary pointer ○
head.
Align the pin on the cam shaft with the slot in
the cam sprocket.
CAUTION:
Do not turn the crankshaft during installation of
the cam shaft. Dam age or improper valve
timing will result.
While holding the camshaft, temporarily
tighten the bolts .
Remove the safety wire from the timing chain.
4. Install:
Breather plate
Plane washer
5. Install:
Timing chain tensioner
Installing steps:
Remove the tensioner cap bolt
.
Release the timing chain tensioner one-w ay
cam and push the tensioner rod
in.
Install the tensioner with a new gasket
the cylinder.
Install the springs
Tighten the bolt (with gasket) to the specified
torque .
Bolt (chain tensioner)
Cap bolt (timing chain tensioner)
6. Tighten:
Bolt (cam sprocket)
7. Check:
Valve timing
Out of alignment → Adjust.
8. Check:
Valve clearance
260/ 300 cc
on the cam sprocket
c
on the cylinder
d
and springs
all the way
and cap bolt .
onto
ATV SERVICE MANUAL07.0
CHAPTER 3 ENGINE PAGE. 3A- 21