CHAPTER 3B ENGINE 50cc/80cc
3.5.4 Assembling the final gear set
First, install the driving shaft to final gearbox.
Then install the final transmission gear shaft (output
shaft) to the final gearbox.
Attach the countershaft to the final transmission
gearbox.
Install
the
countershaft, install the locating pin and the new
gasket.
Put on the final gearbox cover.
Tighten the bolts of the final gearbox cover.
Assemble the clutch/driving pulley disk.
After assembling, fill it with the gear oil.
Designated gear oil: SEA 15W/40SE
Volume of the gearbox:
Filling: 0.12L
Changing:0.10L
Screw up the oil screw and tighten it
Torque: 17-23N·m 12.5-17ft lbs
Start the engine to check if there is oil leakage.
Check the oil level.
Replenish it with the designated gear oil when the
oil is not sufficient (through the oil checking hole)
resin
washer
to
the
CHAPTER 3B ENGINE
ATV SERVICE MANUAL07.0
PAGE 3B - 39 -