Linhai ATV 260 Service Manual page 327

CHAPTER 8 ELECTRICAL
ATV SERVICE MANUAL 07.0
Segment"RES"should blink.
With the fuel level sensor float at the top (FULL)
position, turn the ignition switch to "ON" and
check the fuel gauge. All segments up to
segment "F"should come on.
If the fuel gauge does not function properly,
check the fuel level sensor
If the fuel level sensor is OK, replace the LCD
Meter.
Fuel level Sensor Inspection
Disconnect the fuel level sensor 2p Green
RESISTANCE(20℃/
connector and connect the ohmmeter to the
FLOAT POSITION
68°)
sensor side connector terminals.
Measure the fuel level sensor resistance with the
TOP(FULL) 4-10Ω
float at the top (FULL)
BOTTOM(RESERVE)
100-110Ω
And bottom (RESERVE) positions.
CHAPTER 8 ELECTRICAL CTRICAL PAGE 8- 38