Assembly Of Carburetor - Linhai ATV 260 Service Manual

Hide thumbs Also See for ATV 260:
Table of Contents

Advertisement

CHAPTER 3B ENGINE 50cc/80cc
ATV SERVICE MANUAL07.0
Checking
Check acceleration pump plate for cracks or
hardening of the rubber.
Replace if necessary.
Check for blocked fuel passages.
Clean by high pressure air.
Reverse steps to reassemble.
Take special care with the accelerator pump plate
to avoid damage.

3.8.3 Assembly of carburetor

Slide carburetor carefully into the manifold making
sure to align the tab on the manifold with notch on
the carburetor.
Securely tighten the clamp screw to fix the
carburetor in place. Do not over tighten the screws
as this can cause damage to the manifold.
Attach the inlet pipe to the rear of the carburetor
and tighten the clamp screw.
Attach the throttle cable to the throttle on the
throttle plage.
Use the adjusting nut and stop nut to set the cable
tension,
Correct adjustment should allow 1/4 inch of free
play in the cable.
Attach the fuel line from the tank to the inlet on the
carburetor and clamp securely.
Connect the wiring harness form the auto choke to
the proper connection on the main wiring harness.
After starting the engine, set the idle speed using
the idle adjusting screw.
CHAPTER 3B ENGINE
PAGE 3B - 58 -

Advertisement

Table of Contents
loading

Table of Contents