Braking System Inspection; Brake Pad Inspection; Hose/Fitting Inspection; Foor Brake Adjustment - Linhai ATV 260 Service Manual

CHAPTER 2 MAINTENANCE
2.4 BRAKING SYSTEM
INSPECTION
The following checks are recommended to
keep the braking system in good operating
condition. Service life of braking system
components depends
conditions. Inspect brakes in accordance with
the maintenance schedule and before each
ride.
Keep fluid level in the master cylinder
reservoir to the indicated level on reservoir.
Use DOT 3 brake fluid.
NOTE: Use new brake fluid or brake fluid
from a sealed
contamination to system.
Check brake system for fluid leaks.
Check brake for excessive travel or spongy
feel.
Check friction pads for wear, damage and
looseness.
Check surface condition of the disc.

BRAKE PAD INSPECTION

Pads should be changed when friction
material is worn to 3/64" (1mm).

HOSE/FITTING INSPECTION

Check braking system hoses and fittings for
cracks, deterioration, abrasion, and leaks.
Tighten any loose fittings and replace any
worn or damaged parts.
FOOT BRAKE ADJUSTMENT
NOTE
On USA ATV 260 / 300 and B-type, foot brake
is an AUXILIARY brake.
On European ATV 260 / 300 and B-type , foot
brake is the SERVICE brake (MAIN brake)
Use the following procedure to inspect the
on operating
container to avoid
Foot control brake is only for ATV 260 / 300
Adjusting brake pedal for B-Type
If the push rod joint is reinstalled, adjust the push
rod length so that the distance between the
centers of the master cylinder lower mounting
bolt hole and joint pin hole is 83±1mm.After
adjustment, tighten the joint nut.
CHAPTER 2
ATV SERVICE MANUA 07.0
MAINTENANCE PAGE. 2- 12