Linhai ATV 260 Service Manual page 270

CHAPTER 6 TRANSMISSION
8. Remove front drive output housing cover
screws. Carefully remove the cover with a
soft face hammer tap on the cover bosses.
9. Note position of shim washers and thrust
button.
10. Remove shafts as an assembly.
11. Clean all components and inspect for wear.
12. Inspect engagement dogs of gears and
replace if edges are rounded.
13. Inspect gear teeth for wear, cracks, chips
or broken teeth.
14 . Remove seals from transmission case.
IMPORTANT:
New seals should be installed
after the transmission is completely
assembled.
15. Inspect bearings for smooth operation.
Check for excessive play between inner
and outer race.
ATV SERVICE MANUAL 07.0
CHAPTER 6 TRANSMISSION PAGE. 6- 9