Inner Cv Joint Inspection - Linhai ATV 260 Service Manual

CHAPTER 5 FINAL DRIVE
disassembled or repaired, if damage
or faulty the drive axle assembly must
be replace.
1. Open the clamps on both boot band"A"
and " B" on the inner CV joint, then remove
boot band"B".Discard the boot band, it
cannot be reused.
2. Carefully slide the boot (A) onto the drive
axle and off the inboard joint.
3. Wipe out all of the molybdenum disulfide
grease within the inboard joint cavity.
4. Remove the stopper ring from the inboard
joint.
5. Remove the inner CV joint.
6. Remove the circlip and slide off the
bearing assembly. Be careful not to drop
any of the steel balls from the bearing
cage.
7. slide the inner CV off the drive axle and
discard the boot band"A" ，it cannot be
reused.
8. If the outboard
replacement, perform the following:
a. Open the clamps on both boot bands
"A"and"B" on the outer CV joint,
then remove boot band"B".Discard
the boot band, it cannot be reused.
b. Slide the outboard boot off the drive
axle and discard the boot band "A" , it
cannot be reused.
9. Inspect the drive axle as described in this
chapter.

INNER CV JOINT INSPECTION

1. Clean the bearing assembly in solvent
and thoroughly dry.
2. Inspect the steel balls, bearing case and
the bearing race for wear or damage.
3. Check for wear or damage to the inner
splines of the bearing race.
4. If necessary, disassembly the bearing
assembly for further inspection. Carefully
remove the steel balls from the bearing
cage then remove the bearing race from
the bearing cage.
boot requires
Remove the stopper ring
Inspect groove
CHAPTER 5
ATV SERVICE MANUAL 07.0
FINAL DRIVE. 5- 9