Linhai ATV 260 Service Manual page 52

CHAPTER 3A ENGINE
WARNING:
Do not remove the radiator cap when the
engine and radiator are hot. Scalding hot
fluid and steam may be blown out under
pressure, which could cause serious injury.
When the engine has cooled, open the
radiator cap as follows:
Place a thick rag or a towel over the radiator
cap. Slowly rotate the cap counterclockwise
toward the detent. This allows any residual
pressure to escape. When the hissing sound
has stopped, press down on the cap while
turning counterclockwise and remove it.
NOTE:
Remove the radiator cap after removing the
drain bolt.
4. Clean:
Radiator
Fill soft water into the filer neck support
(reservoir tank).
5. Install:
Gasket NEW
Drain bolt
6. Loosen:
Hose
7. Connect:
Hose (reservoir tank)
8. Fill:
Radiator
( to specified level
Fill the coolant slowly, until the coolant comes
out from the head hose.
Reservoir tank
( to maximum level ○
Recommended coolant:
High quality ethylene glycol anti-freeze
260/ 300 cc
)
)
a
ATV SERVICE MANUAL07.0
CHAPTER 3 ENGINE PAGE. 3A- 15