Wheel, Hub, And Spindle Torque Table; Front Hub Disassembly/Inspection - Linhai ATV 260 Service Manual

CHAPTER 5 FINAL DRIVE
5.1 WH E E L , H U B , AND SPINDLE TORQUE TABLE
Front W
Rear W
Front Hub Nut on Spindle/ outer CV joint
Rear Hub Retaining Nut
CAUTION
: Locking nuts, and bolts with pre-applied locking agent should be replaced if
removed. The self- locking properties of the nut or bolt are

5.2 FRONT HUB DISASSEMBLY/INSPECTION

1. Elevate front end and safely support
machine under footrest/frame area.
CAUTION
Serious injury may result if machine tips
or falls. Be sure machine is secure
before beginning this service procedure.
Wear eye protection when removing
bearings and seals.
2. Check bearings for side play by grasping
tire/wheel firmly
movement. It should rotate smoothly
without binding or rough spots.
3. Remove wheel nuts and wheel.
4. Remove brake caliper
5. ove hub cap, cotter pin, front
Rem
spindle nut,
and w
otate each bearing by hand and check
6. R
for ooth rotation. Visual
sm
bearing for moisture, dirt, or corrosion.
Replace bearing
corrosion, or roughness is evident.
7. Place a shop towel on hub to protect
surface. Carefully pry seal out of hub. Do
not damage the surface of the seal. Clean
Item
heel Nuts
heel Nuts
and checking
asher.
y inspect
l
oisture,
if m
20 Ft.Lbs 27 N.m
50 Ft.Lbs
Refer to FRONT HUB INSTALLATION
80 Ft.Lbs
reduced or destroyed during rem
for
dirt,
ATV SERVICE MANUAL 07.0
Specification
69 N.m
110.6 N.m
CHAPTER 5 FINAL DRIVE. 5-
oval.
2