Table of Contents
Advertisement
CHAPTER 8 ELECTRICAL
4.Thermo unit
Drain the coolant and remove the
thermo unit from the cylinder head.
Immerse the thermo unit
coolant
.
Thermometer.
Coolant
temperature
47.5~56.8Ω
80℃
100 ℃
26.2~29.3Ω
MEETS SPECIFICATION
8.
Voltage
Connect the pocket tester (DC20V) to
the
Temperature gauge couple.
Tester (+) lead→Green/Blue terminal
Tester (-) lead→Green ground
Turn the main switch to on.
Check
for
voltage
temperature gauge lead.
8.
Wiring connection check the
connections of the entire cooling
system.
Refer to "CIRCUIT DIAGRAM"
Replace the temperature gauge
in the
Resistance
(12V)
on
the
ATV SERVICE MANUAL 07.0
Handle the thermo unit with
special care.
Never subject it to strong
shocks or allow it to be
dropped.
Should it be dropped, it must be
replaced.
Do not touch the thermo unit to
the bottom of the heated vessel.
OUT OF SPECIFICATION
Replace the thermo unit
OUT OF SPECIFICATION
The wiring circuit from main
switch to temperature gauge
is faulty. Repair.
POOR CONNECTION
CORRECT
CHAPTER 8 ELECTRICAL CTRICAL PAGE 8- 24
Advertisement
Table of Contents
Troubleshooting
