Burnishing Procedure; Fluid Replacement/Bleeding Procedure; Blade Bleeding-Fluid Change - Linhai ATV 260 Service Manual

CHAPTER 7 BRAKES
Check and adjust master cylinder reservoir fluid level after pad service.
Make sure atmospheric vent on reservoir is unobstructed.
Adjust foot brake after pad service.
Test for brake drag after any brake system service and investigate cause if brake drag is
evident.
Make sure caliper moves freely on guide pins (where applicable) .
Inspect caliper piston seals for foreign material that could prevent caliper pistons from
returning freely.
Perform a brake burnishing procedure after install new pads to maximize service life.

7.4 BURNISHING PROCEDURE

Brake pads (both hydraulic and mechanical) must be burnished to achieve full braking
effectiveness. Braking distance will be extended until brake pads are properly burnished. To
properly burnish the brake pads, use the following procedure.
1. Choose an area large enough to safely accelerate the ATV to 50 km/h (30 mph ) and to brake
to a stop.
2. Using hi gear, accelerate to 50 km/h (30 mph); then compress brake lever (pedal) to
decelerate to 0-8km/h (5 mph).
3. Repeat procedure on each brake system 20 times until brake pads are burnished.
(4. Adjust the mechanical parking brake (if necessary).)
5. Verify that the brake light illuminates when the hand lever is compressed or the brake pedal is
depressed.
WARNING
Failure to properly burnish the brake pads could lead to premature brake pad wear or brake loss.
Brake loss can result in severe injury.

7.5 FLUID REPLACEMENT/BLEEDING PROCEDURE

NOTE : When bleeding the brakes or
replacing the fluid always start with the caliper
farthest from the master cylinder.
CAUTION
Always wear safety glasses.
CAUTION
Brake fluid is highly corrosive. Do not spill
brake fluid on any surface of the ATV.
BRAKE BLEEDING-FLUID CHANGE
This procedure should be used to change fluid
or bleed brakes during regular maintenance.
ATV SERVICE MANUAL 07.0
CHAPTER 7 BRAKES PAGE. 7- 3