Linhai ATV 260 Service Manual page 98

CHAPTER 3A ENGINE
Mechanical sea , slip ring side
Inspect the slip ring side of the mechanical seal
and the impeller
Incorrect level → Reinstall.
4. Install:
Impeller shaft
Circ lip NEW
Installation steps:
Apply a small amount of grease to the impeller
shaft tip.
Install the impeller shaft while turning it. Use
care so that the oil seal is not damaged or the
spring does not slip off its position.
NOTE:
After installing the impeller shaft, check it for
smooth rotation.
5.Install:
O-ring NEW
6. Install:
Water pump housing
Housing cover
7. Install:
Shaft
Align the slot on the impeller shaft with the
projection on the shaft when installing.
3.11.3THERMOSTAT
260/ 300 cc
for level installation.
ATV SERVICE MANUAL07.0
CHAPTER 3 ENGINE PAGE. 3A- 61