Wheel, Hub And Spindle Torque Table; Front Hub Disassembly/Inspection - Linhai M565Li T3 EFI Service Manual

CHAPTER 5 FINAL DRIVE
5.1 WH E E L , H U B , AND SPINDLE TORQUE TABLE
Front W
Rear W
Front Hub Nut on Spindle/ outer CV joint
Rear Hub Retaining Nut
CAUTION
: Locking nuts, and bolts with pre-applied locking agent should be replaced if
removed. The self- locking properties of the nut or bolt are

5.2 FRONT HUB DISASSEMBLY/INSPECTION

1. Elevate front end and safely support
machine under footrest/frame area.
CAUTION
Serious injury may result if machine tips
or falls. Be sure machine is secure
before beginning this service procedure.
Wear eye protection when removing
bearings and seals.
2. Check bearings for side play by grasping
tire/wheel firmly
movement. It should rotate smoothly
without binding or rough spots.
3. Remove wheel nuts and wheel.
4. Remove brake caliper
5. ove hub cap, cotter pin, front
Rem
spindle nut,
and w
otate each bearing by hand and check for
6. R
ooth rotation. Visual
sm
for moisture, dirt, or corrosion. Replace
bearing oisture, dirt, corrosion, or
if m
roughness is evident.
Item
heel Nuts
heel Nuts
and checking
asher.
y inspect bearing
l
Refer to FRONT HUB INSTALLATION
reduced or destroyed during rem
for
M565Li SERVICE MANUAL 2019.0
Specification
69 Ft.Lbs 96 N.m
69 Ft.Lbs 96 N.m
101Ft.Lbs 137N.m
CHAPTER 5 FINAL DRIVE. 5-
oval.
2