Steering Balance(St-Balance); Steering Sub Trim(St-Subtrim); Steering Trim Rate(Trimrate) - Ko Propo EX-1 Instruction Manual

Steering Balance(ST-Balance)

Adjust the left/right steering angles independently. This enables
the turning radii to match up during cornering.
(N:Neutral L:Left R:Right)
Balance L Position
Travel Position
Setting Range ( :70%)
Default
L:30 - 100%
R:30 - 100%
The set percentage is a ratio of the value set by the Steering
Travel.
Steering balance can be adjusted by using the steering wheel
and ET key!
If an ET key that is assigned to steering trim is pressed while the
steering is turned over halfway in either direction, the balance of
the direction of the turn can be adjusted.
However, this cannot be done while on the Function Menu or
System Menu screens.
If the trim is set to a large value, a large left/right value discrepancy
may result. If adjusting steering balance for the first time, follow the
procedures below.
Set trim value to 0.
Adjust sub trim so that the car drives in a straight line when
steering is in neutral position.
Use steering travel to match the overall steering angle range.
Use steering balance to match the left/right turning radii.
If the car does not drive straight at this point, use trim to correct.
Balance R Position

Steering Sub Trim(ST-SubTrim)

Adjust the position of the overall steering angle range. Use this
to match the neutral position when installing the steering servo.
Also refer to Trim and Sub Trim Operation.(p.14)
Example
The servo horn position can be adjusted by the linkages, etc.
when the servo is installed onto the model, but in case this does
not set the neutral position, this function can be used to set it
from the transmitter.
Sub Trim Position
Steering Angle Image
Setting Range L80 - 0 - R80(
If the sub trim value becomes large, adjust the servo horn position
or linkages so that the value becomes closer to 0. If the sub trim
value is too large, dead zones could result and the servo may not
operate at the extremities of its movement range.

Steering Trim Rate(TrimRate)

Adjusts the amount of movement associated with one click of
the trim button. This setting screen is common with the throttle.
Setting Range
STEERING:1 - 10 intervals (
THROTTLE:
see Throttle Trim Rate
Although the amount of movement of one interval can be adjusted,
the lower the number the smaller the amount of movement.
The overall number of intervals does not change, so a change in
trim rate will result in a change in the range in which the trim can
be used to make corrections.
If the trim rate is changed when the trim is already set, the trim
may be thrown off.
apply.)
Lower trim rates enable fine adjustments, but the effects may not be
apparent depending on the servo used. If there is a lot of slop in the
linkage or servo saver, fine trim adjustments could cause the user to
constantly worry about the trim settings. In that case, please reexamine
the linkages, etc.
21
(N:Neutral L:Left R:Right)
(Dotted Line:Neutral Position)
:0)
Default
Default
:5)
If the trim setting is 0 then this does not