Throttle Brake(Th-Brake); Throttle Sub Trim(Th-Subtrim); Throttle Trim Rate(Th-Trimrate) - Ko Propo EX-1 Instruction Manual

Throttle Brake(TH-Brake)

Adjust the maximum amount of brake movement.
(N:Neutral F:Forward B:Brake)
High Point
Setting Range 0 - 150(
Default
On glow engine cars, an overly high setting value will increase
load on the servo and lead to it being damaged. Check carefully
while adjusting.
On electric cars, a setting value that is too small may cause
problems with the ESC settings. Make adjustments starting from
the default setting (100).
Brake will not operate if the value is set to 0.

Throttle Sub Trim(TH-SubTrim)

Adjust the position of the overall throttle movement range. Use
this function when the neutral position cannot be centered with
only linkage adjustment.
Also refer to Trim and Sub Trim Operation. (p.14)
Example
The servo horn horn position can be adjusted by the linkages,
etc. when the servo is installed onto the model, but in case the
neutral position cannot be centered, this function can be used to
set it from the transmitter.
(N:Neutral F:Forward B:Brake)
Sub Trim Position
Steering Angle Image
Setting Range F80 - 0 - B80 (
If the sub trim value becomes large, adjust the servo horn position
or linkages so that the value becomes closer to 0. If the sub trim
value is too large, dead zones could result and the servo may not
operate at the extremities of its movement range.
Brake Position
:100)
(Dotted Line:Neutral Position)
:0)
Default

Throttle Trim Rate(TH-TrimRate)

Adjusts the amount of movement associated with one click of
the throttle trim button. This setting screen is common with the
steering.
Setting Range
STEERING:
see [Steering Trim Rate]
THROTTLE:1 - 10 intervals (
The overall number of intervals does not change, so a change in
trim rate will result in a change in the range in which the trim can
be used to make corrections.
If the trim rate is changed when the trim is already set, the trim
may be thrown off.
apply.)
Lower trim rates enable fine adjustments, but the effects may not
be apparent depending on the servo used. If there is a lot of slop
in the linkage or servo saver, fine trim adjustments could cause
the user to constantly worry about the trim settings. In that case,
please reexamine the linkages, etc.
Although the amount of movement of one interval can be adjusted,
the lower the number the smaller the amount of movement.
26
:5)
Default
If the trim setting is 0 then this does not