Registering A User Card; Deleting A User Card; Cloning Users - Teletek electronics ECLIPSE 8 User's Operation Manual

ECLIPSE 8/16/32/99 Series – User Operation Manual
LED 8/LED 16A
Enter at the address 10 and choose a user number - the LED for zone 1 is blinking on the
display. The digit buttons corresponding to the set proxy options are lighting on in red. To
change settings, press the respective button number according the table above.
The final choice is confirmed by pressing the ENTER button.

5.12 Registering a User card

Registering a user card is done in menu "1. USERS – xx. User – 07. User Card" or
Address 11, after entering manager code:
Address /
User
1. USERS - xx. User -
Manager code
number
Put the card over
07. User Card
the reader
See also the detailed description of item 4.5.

5.13 Deleting a User card

Deleting a card is done again in menu "1. USERS – xx. User – 07. User Card" or Address
11, after entering a manager code:
Address /
Press and hold
1. USERS - xx. User -
for 2-3 sec.
Manager code User
07. User Card
number
See also the detailed description of item 4.6.

5.14 Cloning Users

Attention: This menu is available for ECLIPSE 32/99 control panel only.
This is an address for copying (cloning) of attributes, rights, associations, timeslots and
rights for work with proxy cards. The address allows the settings of one user code to be
copied to one or more users, which saves the need to program setting for every user
separately.
Cloning is done in menu "1. USERS – xx. User – 08. User Clone" or Address 13, after
entering manager code:
Address /
1. USERS - xx. User -
Manager code
08. User Clone
34