Honda Prelude 1993 Service Manual page 177

Timing Belt and Timing Balancer Belt
Replacement
CAUTION: Insp€ct th€ wst€r Frmp whon roplacing tho
timhg boh (pag6 1O-121.
NOTE: Turn the crankshaft so that the No. 1 Diston is at
TDC {page 6-106}.
1, Remove the splash shield.
SPLASH SHIELD
2.
Disconnect the connector, then remove the cruise
control actuator,
NOTE:
a Oo not disconnect the control cable.
a Take care not to bend the cable when removing the
actuator, Always replace a kinked cable with a new
one.
CBUISE CONTROL
ACTUATOR
6 x 1 . 0 m m
10 N.m ('l.O kg-m,
7 tb-fr)
CONNECTOR
TERMINAL
6 - 1 0 9
Remove the mounting bolts, nuts and belt from the
power steering (P/S) pump.
NOTE:
o Do not disconnect the P/S pipe and hose.
o After installing, adjust the tension of the P/S pump
belt (see section 171.
MOUNTING EOLTS
LOCKNUT
1 5 N m ( 1 . 5 k g - m ,
ALTERNATOR
COI{NECTOR
l l
MOUNTING NUT
8 x 1.25 mm
22N m 12.2 kg-m,
16 tb-ft)
8 x 1 , 2 5 m m
22N,m 12.2 kg-m,
P/S PUMP BELT
16 tb-ft|
Disconnect the ahetnator terminal and the connector.
then remove the engine wire ha.ness from the body
srde.
Loosen the ahernator mounting bolt, nut and th€ ad-
justing nut, then remove the alternator belt.
NOTE: After installin€, adjust the tension of the atter-
nstor belt (see section 23).
MOUNTNG AOLT
1O x 1.25 mm
45 N.m (4.5 kg-m,
33 tb-ft)
AL
BELI
(cont'dl