Honda Prelude 1993 Service Manual page 132

Timing Belt and Timing Balancer Belt
Replacement
CAUTION: lmpoct tho water pump whon roplacing the
timing b€h lpags 10-12).
NOTE; Turn the crankshaft so that the No. I oiston is at
TDC (page 6-62).
1. Remove the sDlash shield,
Disconnect the connector, then remove the cruise
control actuator.
NOTE:
a Do not disconnect the control cabte.
. Take care not to bend the cable when removing the
actuator. Always replace a kinked cable with a new
one.
CNU|sE CONTROL
ACTUATOR
6 r 1 . 0 m m
1 o N m ( 1 . o k g - m ,
7 tb-ft)
SPLASH SrmU)
3. Removethe mounting bolts, nuts and poly-V-b€lt from
the power steering (P/Sl pump.
NOTE:
. Oo not disconnect the P/S piDe and hose.
. After installing, adiust the tension ot the P/S pump
belt (see section 1 71.
P/S PUMP
LOCKI{UT
' 1 5 N . m ( 1 . 5 k g - m ,
1 1 tb-ft)
BOLTS/T{UTS
8 r 1.25 rfn
22 N.m 12.2 kg-m,
16 rb-ftt
Disconnect the alternator terminal and the connector,
then remove the engine wire hamess from the cylinder
head cover.
Loosen the altemator mounting bolt, nd rnd the ad-
iusting boh, then remove the ahernator beh.
NOTE: After installing, adiust the tension of the alter-
nator beh {see section 23).
4.
J:aLIERNlton
ool{]{ECTOR
MOUI{TIXG BOLT
tO x 1.25 mrn
45 N.m (4.5 kg{, 33 lb-ft)
ADJUSTING MOUNTI{G NUT
B O L T
8 x t . 2 5 m m
22 N.m {2.2 kg-m,
16lb_ft}
ALTERI{ATOR
BELT
(cont'd)
6-63