Honda Prelude 1993 Service Manual page 130

Timing Balancer Belt
Inspection
1 , Disconnect the alternator terminal and the connector,
then remove the engine wire harness from the cylinder
head cover.
2. Remove the cylinder head cover.
3. Remove the middle cover.
4. Remove the crankshaft pulley.
5. Remove the lower cover.
6. Install the crankshaft pulley.
7.
Inspect the timing belt for cracks and oil or coolant
soaking.
NOTE:
a Replace the belt if oil or coolant soaked.
o Remove any oil or solvent that gets on the belt.
Rotate pullgy
and inspect bglt.
After insp€cting, retorquethe crankshaft pulley bolt to
22O N.m (22.O kg-m, 159 lb-ft).
NOTE: Refer to psge 6-66 for timing batancer belt
tension adiustm€nt.
6 -6 1