Honda Prelude 1993 Service Manual page 134

t
1 3. Lock the timing belt adluster arm in place by install-
ing one of the 6 x 1 .O mm lower cover mounting
bolts,
14. Loosen the timing belt adjusting nut. Push on the pul-
leyto remove tension from the timing balancer belt,
then tighten the adjusting nut.
'15.
Remove the timing balancer belt.
NOTE: lf you are removing only the timing balancer
belt, go to step 21 . li you are removing both belts,
continue with this procedure.
TIMING BELT
ADJUSTER ARM
16. Loosen 6 x 1 .O mm lock bolt and the adjusting nut.
Push on the timing belt adjuster pulley to remove ten-
sion trom the belt, then tighten the adjusting nut.
17. Remove the timing b€lt.
18. lnstall the timing beh in the reverse order of removal.
- Before installing the timing belt, position the crank-
shaft and camshaft pulleys as shown on page
6-62.
19. Per{orm the timing belt tension adiustment
6-60t.
{page
20. Tighten the 6 x 1 .O mm bolt to lock the timing belt ad-
ruster arm.
ADJUSTING t{UT
45 N.m (4.5 kg-m, 33 lb-ft)
(cont'd)
6 -6 5