FUTABA T18SZ Instruction Manual page 130

AIL → Camber flap
This mix operates the camber flaps (FLP1/2)
in the aileron mode. When the aileron stick
is manipulated, the ailerons and camber flaps
perform aileron operation simultaneously and
the operation characteristic of the roll axis is
improved.
The aileron left/right mixing rate of each ap servo
can be ne-tuned.
A mixing curve can be set.
An ON/OFF switch can be set.
Linking is possible: Link this mix to other mixes.
Select [AIL Camber flap] at the
model menu and call the setup
screen shown below.
Return to Model menu
● Mixing curve setting
(For a description of the
setting method, see the
description at the back
of this manual.)
Activate the function by
tapping the [INH].
Condition group/single
mode selection (Gr. /Sngl)
The ON/OFF switch of
mixing is chosen.
To set linking, tap to
the [OFF] item
Setting method
Tap [INH].
(ON is displayed.)
When setting a switch, tap the [--] item of
the switch and tap the screen to call the
selection screen, and then select the switch
and set its ON direction. (Always ON at "--"
setting)
(For a description of the switch selection
method, see the description at the back of
this manual.)
Tap the left or right item of each ap servo.
Adjust the mixing rate.
＜ Model menu (Airplane/Glider/Multicopter Functions) ＞
130
[Corresponding model type]: Airplane/
glider, 2 ailerons + 2 aps or more
Currently selected condition name
*When the mixing direction is reversed by the linkage,
A mixing curve can be set. (1/2 page)
To set linking, tap the [Link] item.
FLP 1
(Camber Flap)
AIL1
(Main Aileron)
AIL 3
(Chip Aileron)
adjustments can be made by changing the mixing rate
(For a description of the mixing curve setting
method, see the description at the back of
this manual.)
Set it to ON and tap the screen.
FLP 2
(Camber Flap)
AIL 2
(Main Aileron)
AIL 4
(Chip Aileron)
Left/right overall
adjustment at Rate A
and Rate B
Adjustment of each
flap servo