FUTABA T18SZ Instruction Manual page 89

Timer
Select [Timer] at the linkage menu and call the setup
screen shown below.
Return to
Linkage menu
[Inhibit] → [Type1-4]
If it carries out like this,
a vibration function
will work.
Up timer/Down timer selection
1. Tap the mode button and select the type of
timer.
2. Timer time setting.
Tap the Mode minutes or seconds button.
Value input buttons appear on the screen.
Use these buttons to set the timer time.
Timer setting
Time ：
OFF: Turning the power OFF and switching models will reset the timer.
ON: Previous timer is put into memory and will restart from where it stopped.
[Start/Stop] → Home screen
A timer on the home screen starts and stops its countdown
directly from there when tapped. Tapping and holding the
display will reset the timer.
Timer 1
Last twenty seconds Last ten seconds
One short
Alarm :
beep
Timer 2
Start/Stop/Reset switch setting
1. Tap the Start/Stop/Reset SW "--" button to
call the Switch screen, and then select the
switch and its ON direction.
(For a detailed description of the selection
method, see [Switch selection method] at
the back of this manual. The timer switches
can be set for each condition.)
Target time
Two short
Continue counting
Also
beeps
with displaying a
minus (-) sign.
beep
E l a p s e d : M i n u t e -
b y - m i n u t e a l a r m
starting from 00:00
Remainder : Minute-
b y - m i n u t e a l a r m
counting down from
a designated time
＜ Linkage menu ＞ 89