Telemetry : Servo Sensor [Current] - FUTABA T18SZ Instruction Manual

Telemetry : Servo sensor [Current]

Select [Servo sensor] in the Telemetry
screen and access the setup screen shown
below.
Return to Linkage menu
Max. and min. values
s i n c e t h e p o w e r
was turned ON will
display.
When the Alarm or
Vibrator options are
activated, the servo
connection will
display.
*This alarm and display is limited to the S.BUS
servos connected to the servo sensors.
↑ An upward arrow
indicates the alarm
will sound when the
current reaches above
your set value.
↓ A downward arrow
indicates the alarm
will sound when the
current reaches below
your set value.
Alarm is chosen from
Buzzer, Voice, and
Inhibit.
The ON/OFF switch
of Speech is chosen.
*Servo sensor must be installed in the aircraft.
Tapping this and selecting
"Buzzer" will cause the device
t o s o u n d a n a l a r m w h e n
servos are not connected.
Vibrator is chosen from
type1-3, and Inhibit.
Tap here and go to the
Servo 2 settings page.
(Display and settings
content is the same as
Servo 1.)
Tapping this and selecting
"Each type" will cause the
device to vibrate when servos
are not connected.
A setup of the
current on which the
alarm operates.
Initial value: ↑ 10.0A ↓ 0.0A
Adjustment range 0.0A 10.0A
( ↑ Limit ≧ ↓ Limit)
＜ Linkage menu ＞
Tapping this will
take you to the
settings screen for
the current alarm
109