Camber Mixing - FUTABA T18SZ Instruction Manual

Camber mixing

This function adjusts the rate of camber
operation which operates the wing camber
(ailerons, camber flaps, brake flaps) in the
negative and positive directions. The aileron,
flap, and elevator rates can also be adjusted
independently by curve, and attitude changes
caused by camber operation can be corrected.
*Initial setting assigns camber operation to side lever LS.
Select [Camber mixing] at the model
menu and call the setup screen
shown below.
Activate the function by
tapping the [INH].
Condition group/single
mode selection (Gr. /Sngl)
The ON/OFF switch of
mixing is chosen.
Condition delay cut
switch
Condition delay setting
Return to Model menu
Ailerons, flaps
and elevators rate
adjustment
● Mixing curve setting
(For a description of the
setting method, see the
description at the back
of this manual.)
＜ Model menu (Airplane/Glider/Multicopter Functions) ＞
134
[Corresponding model type]: Airplane/glider, 2 ailerons or more
The up/down side rates of the aileron, ap, and
Mixing during ight can be turned ON/OFF by
A delay can be set for each condition. A cut
The speed of the aileron, ap, and elevator servos
Currently selected condition name
elevator servos can be adjusted by curve. When
the mixing direction is reversed by the linkage,
adjustments can be made by changing the
mixing rate polarity (+ or -).
setting a switch. (Always ON at [--] setting)
switch which can turn OFF the delay function can
be set.
can be set. (In side/Out side)
Servo speed setting
(For a description of the
setting method, see the
description at the back
of this manual.)
Overall adjustment by
Rate A and Rate B.