FUTABA T18SZ Instruction Manual page 34

DANGER
Don't touch wiring.
* There is a danger of receiving an electric shock.
Do not short-circuit the battery
terminals.
* A short circuit across the battery terminals may
cause abnormal heating, fire and burns.
Please double check your polarity
( ＋ and − ) when hooking up your
connectors.
* If ＋ and − of wiring are mistaken, it will damage,
ignite and explode.
Don't connect to Extra Voltage before
turning on a receiver power supply.
The R7008SB receiver is a very versatile
unit. It has 8 PWM outputs, S.BUS and S.BUS2
outputs. Additionally the PWM outputs can be
changed from channels 1-8 to channels 9-16. If
you only desire to use it as an 8 channel receiver
(without S.BUS), it can be used without any
setting changes.
The T18SZ has the ability to link to two
R7008SB receivers. One of them outputting
channels 1-8 and the other outputting channels
9-16 gives you 16 PWM channels. Instructions
for this configuration and S.BUS operation
follow.
Receiver
connector
1
2
3
4
5
6
7/B
8/SB
Red LED blink
＜ Before Use ＞
34
R7008SB CH MODE TABLE
Mode A
1 ∼ 8CH 1 ∼ 7CH
1
2
3
4
5
6
7
8
1 time
[How to change the R7008SB Channel mode.]
1. Press and hold down the Link/Mode button
on the
2. Turn the receiver on while holding down
the Link/Mode button. When the LED
begins to blink green/red the button may
be released.
3. The LED should now be blinking red in one
of the patterns described by the chart
below.
4. Each press of the Mode/Link button
advances the receiver to the next mode.
5. When you reach the mode that you wish
to operate in, press and hold the Mode/
Link button for more than 2 seconds.
6. Once locked into the correct mode the
LED will change to a solid color.
7. Please cycle the receiver(s) power off and
back on again after changing the Channel
Mode.
Setting channel
Mode B Mode C
9 ∼ 16CH
1
2
3
4
5
6
7
S.BUS
2 times 3 times
receiver.
Mode D
9 ∼ 15CH
9 9
10 10
11 11
12 12
13 13
14 14
15 15
16 S.BUS
4 times