FUTABA T18SZ Instruction Manual page 21

When turning on the power, the T18SZ transmitter will begin emitting RF automatically after it
part of the front of a T18SZ.
Throttle Stick Low
*If the throttle stick is in the high position when the
power is turned ON
Warning alarm
If the power switches are turned off in the opposite order the model may unexpectedly run out of control and
cause a very dangerous situation.
1. Turn on the transmitter power switch.
2. Turn on the receiver or speed control power switch.
ON
*If THR stick is high, a WARNING screen will appear. Another warning will appear if a power
supply is attached. (In Multicopter mode, the THR position alarm will not appear.)
Power Switch
Right or Left Long Push
ON
Power Switch
Right and Left Push
When the alarm activates, lower the throttle stick
before turning the receiver power ON.
*If the power is turned ON when the idle-up, air brake,
etc., switches are ON, the above warning will display.
Ensure the relevant switches are turned OFF.
Tap this to stop the alarm
a n d R F s i g n a l . O n l y p a n e l
screen operation is active, the
transmitter will not link to any
receiver.
Always be sure the motor/engine is stopped.
1. Turn off the receiver or speed control power switch.
2. Then turn off the transmitter power switch.
OFF
Power Switch
or
Right or Left Long Push
OFF
＜ Before Use ＞ 21