S.bus Servo - FUTABA T18SZ Instruction Manual

S.Bus servo

An S.BUS(2) servo can memorize the channel
and various settings you input. Servo setting can
be performed on the T18SZ screen by wiring the
* With some S.BUS(2) servos, there are some functions which
cannot be used. If a function cannot be used, the display
screen will change. (Only the function which can be used by
a servo is displayed.)
if a stick is moved, servo operation can be tested.
Call the following setting screen by pressing the
[S.BUS Servo] button in the System menu.
Return to System menu
Procedure for changing S.BUS servo setting
1. Select [S.Bus servo] of the System menu.
2. Wire the servo as shown in the gure above.
3. Press [Read]. The ID and current setting of
that servo are displayed.
If you use multiple S.BUS servos, only the desired
servo in the group can be set by entering the ID of
S.BUS servo setting
4. When multiple servos are connected change
[INH] at the right side of the ID number on the
screen to [ACT] and enter the ID of the servo
you want to set.
5. Set each item. (Please see the next page.)
6. Press [Write]. The settings are changed.
＜ System menu ＞
S.BUS/S.BUS2
Servo
3-way hub
or Y-harnesses
63