FUTABA T18SZ Instruction Manual page 31

The T18SZ transmitter model data can be stored by using any commonly found SD card. When
T18SZ transmitter update software is released, the software is updated using an SD card. The T18SZ is
capable of using SD cards with a memory size between 32MB and 2GB.
Saving model data and update files (released
from Futaba) into the SD card, you can use those
files on your T18SZ transmitter. Equipment for
reading and writing SD cards is available at most
electronics stores.
When you have a problem of saving or reading
data after a long period of use, please get a new SD
card.
*We are not responsible for, and offer no compensation for,
memory card data that fails or is damaged for any reason.
Be sure to keep a backup of all important data stored in your
SD card.
① The side battery cover
is remove-able.
Battery cover
SD card slot
②The SD card slot is slot is
shown here in the in th h e e e
figure below. w.
*Pay attention to the proper orientation of o the the pr p pr ope ope p
the SD card, as shown here. h h
CAUTION
Be sure to turn off the power to the
transmitter before inserting or removing
the SD card.
As the SD card is a precision device, do
not use excessive force when inserting.
＜ Before Use ＞
SD card slot
r o r o rie rie i ntati nta t tio tion o n of f f f
③ When the SD card
is pressed in once
again, the card will
be released from the
card slot and can be
removed.
31