Telemetry: Voltage [Battery] - FUTABA T18SZ Instruction Manual

Telemetry: Voltage [Battery]

⇔
Tap the [Voltage] button in the Telemetry screen
to call the setup screen shown below.
Return to
Linkage menu
Max. and min. values
s i n c e t h e p o w e r
was turned ON will
display.
↓ The "down" arrow
will indicate that an
alarm will sound when
the voltage drops to
below the setting.
Alarm is chosen from
Buzzer, Voice, and
Inhibit.
The ON/OFF switch
of Speech is chosen.
Alarm set
1. Tap Alarm and choose from Bu
Voice, and Inhibit.
2. W h e n n o t o p e r a t i n g v i b r a t o r , i t i s
"Vibrator" to Inhibit. Type1-3 will be
chosen if it is made to operate.
3. Tap to the Limit [4.0V] item .
4. Adjust the rate by "
button.
Initial value: 4.0V
Adjustment range: 0.0V~100.0V
5. To terminate the input and return to
the original state, push the HOME/EXIT
button.
⇔
Vibrator is chosen from
type1-3, and Inhibit.
＜ Two examples of wiring are shown ＞
er,
" " " " " " "
Two drive batteries and power supplies for servos are measured (R7008SB use)
Displaying data from the receiver battery voltage
*SBS-01V must be installed in the aircraft.
Two drive batteries are measured (R7008SB use)
Drive battery 1
（EXT Battery)
Drive battery 2
（EXT Battery)
EXT Line
Receiver battery
●Battery voltage measurement for receivers [R7008SB use]
●The drive battery 1 is measured in an EXT port [R7008SB use]
●The drive battery 2 is measured in an EXT line [SBS-01V use]
*SBS-01V measures two voltage. One corresponds to high voltages, such as a drive battery,
with an EXT line. Another is a normal line and is measurement of the battery for receivers of a
line connected to 3P connector, or the battery for servos.
Drive battery 1
（EXT Battery)
EXT Line
Drive battery 2
（EXT Battery)
Power supplies
for servos
S.BUS2
●Battery voltage measurement for receivers [R7008SB use]
servos
●The drive battery 1 is measured in an EXT port [R7008SB use]
●The drive battery 2 is measured in an EXT line [SBS-01V use]
●The voltage for servos is measured in a power supply line [SBS-01V use]
＜ Linkage menu ＞
Battery voltage
A setup of the
voltage on which the
alarm operates.
Normal Line
Normal Line
Receiver battery
103