FUTABA T18SZ Instruction Manual page 132

Aileron → Rudder
Use this mix when you want to mix the rudders
with aileron operation.
A mixing curve can be set.
Mixing during ight can be turned ON/OFF by
setting a switch. (Always ON at [--] setting)
The mixing rate can be ne-tuned by setting a VR.
Select [Aileron Rudder] at the
model menu and call the setup
screen shown below.
Return to Model menu
● Mixing curve setting
(For a description of the
setting method, see the
description at the back
of this manual.)
Activate the function by
tapping the [INH].
Condition group/single
mode selection (Gr. /Sngl)
The ON/OFF switch of
mixing is chosen.
Setting method
Tap [INH].
(ON is displayed.)
When setting a switch, tap to the [--] item
of the switch and tap the screen to call the
selection screen, and then select the switch
and set its ON direction. (Always ON at "--"
setting)
(For a description of the switch selection
method, see the description at the back of
this manual.
When setting a VR, tap to the Fine Tuning
"--" item and tap the screen to call the
selection screen, and then select the VR. The
adjustment rate can be set. The VR operation
mode can also be selected.
A mixing curve can be set.
＜ Model menu (Airplane/Glider/Multicopter Functions) ＞
132
[Corresponding model type]:
Airplane/glider, general
RUDDER 1
Winglet
(
at Flying wing
RUDDER 2
Currently selected condition name
(For a description of the curve setting
method, see the description at the back of
this manual.)
[Fine tuning VR operation mode]
[LIN.] M i x i n g r a t e 0
When the VR is turned clockwise and
counterclockwise, the mixing rate
increases and decreases, respectively.
[ATL+] Mixing rate 0
When the VR is turned, the mixing rate
increases.
[ATL-] Mixing rate 0
When the VR is turned, the mixing rate
increases.
[SYM.] When the VR is turned to the left or
right of the neutral position, the mixing
rate increases.
AIL1
(Main Aileron) (Main Aileron)
AIL 3
(Chip Aileron)
)
V-TAIL
RUDDER
RUDDER
Left/right overall
adjustment at Rate A
and Rate B
Fine tuning VR setting
Operation mode
Adjustment rate
a t c e n t e r o f V R .
at left end of VR.
at right end of VR.
AIL 2
AIL 3
(Chip Aileron)
RUDDER 2
Winglet
( )
at Flying wing