FUTABA T18SZ Instruction Manual page 101

Telemetry : Altitude
Tap the [Altitude] button in the Telemetry screen to
call the setup screen shown below.
Return to
Linkage menu
Max. and min. values
s i n c e t h e p o w e r
was turned ON will
display.
↑ An upward arrow
indicates the alarm
will sound when the
altitude reaches above
your set value.
↓ A downward arrow
indicates the alarm
will sound when the
altitude reaches below
your set value.
Alarm is chosen from
Buzzer, Voice, and
Inhibit.
The ON/OFF switch
of Speech is chosen.
First, the set of a reference is required.
1. The model and transmitter to which the
altitude sensor was connected are turned on.
2. Tap to the [Preset] of "Reference" item.
"Vibrator" type
If the following types are selected, the transmitter
will vibrate during the warning.
Type 1
Type 2
Type 3
*An altitude sensor or GPS sensor must be installed in the aircraft.
The ON/OFF switch
of melody is chosen.
Alarm set : Altitude
1. Tap Alarm and choose from Bu er, Voice,
2. When not operating vibrator, it is "Vibrator" to
3. Tap to the Limit [xxx m] item .
4. Adjust the rate by "
5. To terminate the input and return to the
Displaying data from the altitude
A setup of the altitude
on which the alarm
operates.
and Inhibit.
Inhibit. Type1-3 will be chosen if it is made to
operate.
Initial value: 200m -50m
Adjustment range -500m~+3,000m
( Limit ≧ Limit)
original state, push the HOME/EXIT button.
＜ Linkage menu ＞
Altitude
● If this is set to Mode1-4,
a rise and dive are told
by a different melody.
Mode1: Little rise/dive
→ Melody changes
: sensitively
Mode4: Big rise/dive
→ Melody changes
: insensible
" " " " " " " button.
101