FUTABA T18SZ Instruction Manual page 174

The various functions used in the T18SZ can be selected by switch. The switch (including when stick,
trim lever, or VR are used as a switch) setting method is common to all functions.
Switch selection
When a switch is selected at a mixing function, etc., the selection screen shown below is called.
When switch is selected
Switch ON/OFF setting is possible at each
position.
1. When the ON/OFF "Set" position switch is
tapped after the switch was selected, the
screen shown below appears.
Normal or Alternate: Alternate switching
mode is available depending on mixing
function.
*When the button of each position is tapped,
it toggles between ON and OFF.
2. Tap the button and set to the ON position.
3. Close the screen by tapping [Hardware
select].
174 ＜ Data ＞
(Switch selection screen example)
When stick, trim lever, or VR is selected.
switch, the following 2 modes can be selected.
1. When the ON position button is tapped after
2. Select the mode you want to use, and set it
3. Close the screen by tapping [Hardware
When a stick, trim lever, or VR is used as a
Mode: Linear/Symmetry
stick, etc. was selected, the screen shown
below appears.
as described below.
select].
Tap the chosen
switch.