FUTABA T18SZ Instruction Manual page 165

Usage example #1: Using gyro for only the rudder and adjusting sensitivity for each condition
＊ Gyro gain channel
Gyro : CH5
For the FASSTest12CH, Gyro/RUD is 6ch. The gyro sensitivity adjustment connector connects to 6ch.
Select [Gyro] at the
model menu and call
the setup screen.
Tapping here will let you
select either Normal or
AVCS.
Usage example #2: Using 3-axis gyro CGY750 and adjusting sensitivity for each condition
＊ Gyro gain channel
Gyro RUD : CH5 For the FASSTest12CH, Gyro/RUD is 6ch.
Gyro2 AIL : CH9
Gyro3 ELE : CH10 For the CGY750, simply connect the S.BUS; functions do not need to be set.
(For the FASSTest12CH, change Gyron/RUD to 6ch.)
Select [Gyro] at the
model menu and call
the setup screen.
Tapping here will let
you select either Normal
or AVCS for each of the
three axes.
Set gain of a rudder
Set gain of a rudder
Because sensitivity changes for
h o v e r i n g a n d i d l e u p , p e r f o r m
switchover for each condition and
adjust sensitivity.
Set gain of a aileron
Because sensitivity changes for
h o v e r i n g a n d i d l e u p , p e r f o r m
switchover for each condition and
adjust sensitivity.
This is all that is needed
for use in this case.
This is all that is needed
for use in this case.
Set gain of a elevator
＜ Model Menu (Helicopter Functions) ＞
Because the
sensitivity is switched
(Sngl) per condition,
Rate 2 and Rate 3 are
not used.
Because the
sensitivity is switched
(Sngl) per condition,
Rate 2 and Rate 3 are
not used.
165