Model Type - FUTABA T18SZ Instruction Manual

Model type

Select [Model type] at the linkage menu and call
the setup screen shown below.
Return to Linkage
menu
Model type selection
1. Model type selection [Model icon], tap.
2. Set the Model type, Wing type(Airplane/
Glider), Tail type(Airplane/Glider), or Swash
type(Helicopter) by using the appropriate
button.
3 . S e t t h e t y p e y o u c h o o s e b y t a p p i n g
[Enter] → [Yes] at the confirmation screen.
(When you want to cancel model type
selection, tap [No].)
screen of data initiali ation menu will be displayed.
A push on [yes] will initiali e data and allow changes.
A push on [no] will stop data changes.
72 ＜ Linkage menu ＞
This function selects the model type from among airplane, glider,
helicopter, and multicopter.
When a data change will occur, the confirmation
Note: The Model Type function automatically selects
the appropriate output channels, control functions,
and mixing functions for the chosen model type.
When the Model Type Selection command is
accessed, all of the data in the active memory is
cleared. Be sure that you don t mind losing this data,
or back it up to another memory using the copying
functions.
( The display screen is an example. The
screen depends on the model type.)
2. [Yes], tap
1. [Enter], tap