FUTABA T18SZ Instruction Manual page 40

S.BUS/S.BUS2 servos or a telemetry sensor can be connected directly to the T18SZ. Channel setting and
other data can be entered for the S.BUS/S.BUS2 servos or sensors.
WARNING
Do not disconnect or turn transmitter power OFF
while S.BUS servo and telemetry sensor data is
being saved.
■ S.BUS servo and sensor save data will be lost,
resulting in malfunction.
WARNING
Do not use the S.I/F (S.BUS servo setup) connector
with anything other than high-voltage-capable
S.BUS servos.
■ Transmitter battery voltage (6.6V) is conveyed
directly.
U s i ng a ny t hi n g o t h e r t h a n h ig h- vo l t a g e -
capable servos presents the danger that they
will break.
＜ Before Use ＞
40
1. Connect the S. US device you want to set
with as shown in the gure.
2. Turn on the transmitter power.
3. Call the setup screen.
Servo: System Menu → S. US servo
Sensor: Linkage Menu → Sensor
4. Perform setting in accordance with each
screen.
5. This sets the channel and other data for each
S. US servo, or telemetry device to be used
with the S. US device or receiver.
*It is not necessary to carry out multiple battery
connections like a T18MZ/T14SG.
*When connecting many current-consuming
servos, please use an additional power supply
hub.
And electric power is supplied to a servo with
another power supply.
●When separate power supply used
When a large number of servos are used or
when high current servos are used, the servos
can be driven using a separate Power Supply
3-way hub.
Green
Used when using a separate
power supply battery.