FUTABA T18SZ Instruction Manual page 84

Idle down
Select [Idle down] at the linkage menu and call
the setup screen shown below.
Return to Linkage menu
T h i s i s t h e i d l e d o w n
throttle position. Tapping
t h i s w i l l d i s p l a y v a l u e
input buttons on-screen.
Set the engine's max. slow
position.
Range:
（↑）-100 ∼ +100（↓）
Pressing and holding a
value will reset it to 0.
Idle down setting procedure
1. Tap the "INH" button to activate the Idle
down function.
2. Idle down function switch setting:
Tap the "--" button to call the
select screen, and then select the switch
and its ON direction.
(For a detailed description of the selection
method, see [Switch selection method] at
the back of this manual.)
3. Offset rate setting:
Tap the offset rate button. Value input
buttons appear on the screen.
Use these buttons to adjust the offset rate.
Initial value: 0
Adjustment range: -100 ~100
To exit the setting, tap the [Idle down]
button.
84 ＜ Linkage menu ＞
Lowers the engine idling speed.
−− "
Tapping this will change
INH to either OFF or ON
and activated.
Tapping this will pull up the
hardware selection screen.
Select the idle down switch
and ON-OFF direction.
Hardware
This is the current position bar for the
throttle stick. Idle down will only function
when the throttle stick is more than
halfway into the slow throttle range.