FUTABA T18SZ Instruction Manual page 30

You can choose either airplane ratchet system or helicopter-touch.
*In the Mode 1/3, arrangement of a screw is opposite.
1. Open the dust protection cap on the back of the
transmitter that is covering the hole for throttle stick
adjustment.
2. Use the attached 1.5mm hexagonal wrench (inside
stylus) to turn the adjustment screw and set it as you
prefer. Turning the screw clockwise increases the
tension.
For airplanes: Adjust the screw on the left.
For helicopters: Adjust the screw on the right.
In changing the setting from airplane to helicopter (or
heli to airplane);
1. Turn the screw counter clockwise until the throttle
stick moves freely, and turn the screw clockwise to
adjust it to the tension you prefer.
＜ Before Use ＞
30
*This transmitter has two ratchet plates, one for
airplane and the other one for helicopter. If
you tighten both screws, you won't be able to
*If you want to change the setting from airplane
to helicopter (or from helicopter to airplane),
turn the ratchet screw clockwise until the
throttle stick moves freely. Then turn the screw
for the helicopter until you get the tension you
like.
Airplane
Helicopter