FUTABA T18SZ Instruction Manual page 156

Throttle curve / Throttle Hover trim
This function adjusts the throttle operation curve
for each condition for optimum engine speed to
throttle stick movement.
Up to 17 curve points can be set for the point
curve type. However, when the 5 points and other
Select [Throttle curve] at the model
menu and call the setup screen shown
below.
Return to Model menu
● Mixing curve setting
*For a description of the
curve setting method,
see the description at
the back of this manual.
Throttle hover trim
operating position
(White line)
Normal curve creates a basic curve
centered around hovering. Use it along
with the normal pitch curve and adjust so
that up/down control at a constant engine
speed is easiest.
Set an idle up curve that maintains a
constant speed at all times, even during
operation which reduces the pitch
performed in ight. Create a curve matched
to loop, roll, 3D, or other purposes and the
idle up curve according to the performance.
Setting method
Group/single item: When you want to
simultaneously enter the same settings to
other functions, make the settings in the
group mode. In this case, the same setting
＜ Model Menu (Helicopter Functions) ＞
156
point data is used, a simple curve can be easily
created by reducing the number of input points of
the curve to 5 and entering the specified value at
the corresponding points.
Currently selected condition name
Operation precautions
WARNING
When actually starting the engine and
flying, always set the idle up condition
switch to OFF and start the engine in
the idling mode.
contents are entered to the all conditions.
When you want to set each condition
independently, make the settings after
selecting the single mode (Initial setting).
P o i n t c u r v e t y p e i s 9
points (initial), but for
simple use, 4 5 points
are sufficient.