FUTABA T18SZ Instruction Manual page 61

H/W setting
Usually, this calibration is unnecessary.
Please perform this calibration only if a change
at the center of a stick should arise after prolonged
use.
Tap the [H/W setting] button in the System
menu to call the setup screen shown below.
Return to System menu
How to Calibrate
1. Choose the stick to calibrate right and left.
2. The stick is set at neutral and the [Set neutral]
button is tapped.
3. The stick is held at full right and full bottom
(diagonal). The [Set endpoint] button is
tapped.
4. The stick is held at full left and full top
(diagonal). The [Set endpoint] button is
tapped.
doing the calibration.
*Check after calibration to make sure that neutral is 0%, the
bottom right side is +100%, and the top left side is -100%.
Tapped
The stick is set at
neutral
This is the MODE1 ∼ MODE4 setting.
To change the mode the stick ratchet must be
changed. Request that this be done by Futaba
RUD AIL
ELE THR
MODE 1
AIL RUD
ELE THR
MODE 3
＜ System menu ＞
RUD AIL
THR ELE
MODE 2
AIL RUD
THR ELE
MODE 4
Tapped
Full right and
full bottom
Tapped
Full left and
full top
61