FUTABA T18SZ Instruction Manual page 142

Trim mix 1/2
These functions call the ailerons, elevators, and
The amount of ailerons, elevator, and flaps
a switch.
As an example Trim mix 1 can be set up for
and a slight amount of up elevator. Trim mix
2 can be used for high speed flying, with both
of down elevator.
The trim functions can be activated during
can be set to provide a smooth transition between
the two. Trim mix 2 will have priority over Trim
mix 1.
W h e n u s i n g t h i s
function, Tap [INH].
(ON is displayed.)
The ON/OFF switch of
mixing is chosen.
M a n u a l / A u t o m o d e
selection
Manual: Switches the
f u n c t i o n O N / O F F b y
switch
Auto: Trim mix function
call can be linked to a
stick, etc. A stick switch,
etc. separate from the
function ON/OFF switch
is set.
Condition delay setting
Return to Model menu
＜ Model menu (Airplane/Glider/Multicopter Functions) ＞
142
[Corresponding model type]: Glider, general
Select [Trim mix1 or 2] at the model
menu and call the setup screen
shown below.
Condition delay cut
switch
The ailerons, flaps, and elevators offset rate can be adjusted.
Tap to the corresponding setting item. Adjust the rate.
Example
1. Move to the [INH] item
[ON].
*When separating the settings for each condition, move to
the [Group] item and set it to [Single].
2. Select the ON/OFF switch.
3. Select the [Manual] or [Auto] mode.
In the [Auto] mode, also select an auto SW. This
switch can be linked to a stick, etc.
<Speed>
In: The operation speed at switch ON can be set.
Out: The return speed at switch OFF can be set.
<Fine Tuning>
The offset rate can be varied in the Fine Tuning
numeric range set at screen by VR, etc. selection.
<Condition Delay>
When ight conditions are set, the operation speed
can be set for each condition. Condition delay
operation can be interrupted and each rudder
uickly returned to its original position by selecting a
cut switch.
*The display screen is an example. The actual
screen depends on the Model Type.
To next page
When a fine tuning VR
is set, the ailerons flaps
and elevators trim rates
can be adjusted.
.
Set the trim mix function to
In speed
Out speed
（First） 0 ∼ 27 （ Slowly）
The value inside the
parentheses shows the
current rudder position.