End Point - FUTABA T18SZ Instruction Manual

End point

Tap the [End point] button in the
Linkage menu to call the setup
screen shown below.
Return to
Linkage menu
Servo travel adjustment
1. Tap the travel button of the channel you
want to set. Value input buttons appear on
the screen.
2. Use these buttons to adjust the rate.
Initial value: 100
Adjustment range: 30 ~140
3. Repeat the procedure above for each rate.
Sets the travel, limit point.
Left / Top
Indicates the current
direction of the stick, etc.
(The display screen is an example. The screen depends on the model type.)
30 ∼
140%
Travel rate Limit point
Right / Bottom
Limit point adjustment
1. Tap the limit button of the channel you want
to set.
2. Use the value input buttons to adjust the limit
point.
Initial value: 135
Adjustment range: 0 ~155
3. Repeat this procedure for each limit point.
30 ∼
140%
Next page
7-16 Ch
Tap the values you
wish to adjust and
value input buttons
will appear on-screen.
＜ Linkage menu ＞ 75