Setting method
Group/Single item: When you also want to
input the same setting contents at other
conditions, perform setting in the group
mode. In this case, the same contents are
input to the other conditions set in the group
mode. When you want to set each condition
independently, select the single mode
(initial setting). Other conditions can be set
independently.
Curve setting examples
The screens shown below are curves created
by entering the pitch rate at low, center, and high
side (3 points or 5 points) at each condition. When
the fuselage (or the reference value).
Curve
ample
Normal Curve
< Model Menu (Helicopter Functions) >
154
Idle-up 1 Curve
Pitch servo speed setting
(For a description of the setting method, see the
description at the back of this manual.)
*For a description of the curve setting method, see the
description at the back of this manual.
Idle-up 2 Curve
Hold Curve