FUTABA T18SZ Instruction Manual page 111

Telemetry : Current [Current] [Voltage] [Capacity]
Select [Current] in the Telemetry screen
and access the setup screen shown below.
Return to Linkage menu
Max. and min. values
s i n c e t h e p o w e r
was turned ON will
display.
↑ An upward arrow
indicates the alarm
will sound when the
current reaches above
your set value.
↓ A downward arrow
indicates the alarm
will sound when the
current reaches below
your set value.
Alarm is chosen from
Buzzer, Voice, and
Inhibit.
The ON/OFF switch
of Speech is chosen.
*Current sensor must be installed in the
aircraft.
Current
Voltage
Consumption capacity
"Vibrator" type
If the following types are selected, the transmitter
will vibrate during the warning.
Type 1
Type 2
Type 3
*Refer to the manual of SBS-01C for the details of wiring.
Tapping this will
take you to the
settings screen for
the current alarm
A setup of the
current on which the
alarm operates.
Initial value: ↑ 100A ↓ 0A
Adjustment range 0A 150A
( ↑ Limit ≧ ↓ Limit)
＜ Linkage menu ＞ 111